To go back to normal operation, turn the switch off and wait ~10 seconds, then turn back on.High quality dimmer switch Light bulb (different type or brand) Wire nuts Originally Published: JSimilar Projects. If you turn the switch off and on within a second or so, the light will stay on, and this overrides motion detection. The red wire is the traveler that carries the current from one s.The motion detector monitors ambient light (daylight) and then activates when it's dark enough, and motion is detected. The third wire creates repetitive switching at either end. I tested the power and found good voltage, but when I put my tester to ohm meter and touched the white wire and the conduit, it showed that there is a connection between …A two-way light switch produces light when two of three wires transport a current to either end of the installation. I recently installed a motion sensor light and was called back because the light was 'flickering' at half brightness rather than staying on brightly.
It's domed a little bit, giving it the ability to scan an entire room.Viewed 24k times. On the top, you've got the standard motion sensor. It does look a little different from others on the market, but you'll have no trouble figuring it out. The design of the Topgreener TDOS5-J Motion Sensor Light Switch is quite standard.
